You must find where the pipe is collapsed usually by snake in till you hit the
break or uncovering the pipe till you find the break. Cut both ends of the break
with a saw or chain cutter so you have a nice smooth end. Install a rubber
coupling on both ends slid onto your clay pipe. Measure and cut a replacement
piece of pipe to fit between, slide rubber boots over the seams and tighten.
Be careful not to over tighten and rebreak the pipe. Sewer lines have little
to no pressure so a snug tightening will do. Run water down line and look
for a leak. Cover and silt in dirt and you are ready to go.
You repair a collapsed clay sewer pipe without digging by Pipe pulling.
Yes, but there are requirements for vertical distance between the sewer and water main (generally at least 18 inches) and materials of construction. One reference is the so-called 10 State Standards (Section 38.3). If you do not have access to this publication (e.g., you are a homeowner), check with your local building department.
Yes.
nails, screws, nuts and bolts and car bodies
Through ur city hall or township main building
no because there is nostructural value in a seal weld, its main purpose is to seal
A 3 or 4 inch pipe sticking straight up out of the ground? This is the clean out for the sewer line. If sewage is coming out of it, this means the sewer line is clogged or collapsed from there to the main city sewer. If you have a septic tank, the tank is full and needs to be pumped out.
form_title=Sewer Main Repair form_header=11063 How would you best describe the nature of the project?*= () Install new sewer pipe from home to street () Replace existing sewer pipe from home to street () Repair broken sewer pipe from home to street () Other () Don't Know "Explain why the sewer pipe needs to be installed, replaced, or repaired."*= [] Bathtubs and sinks drain slowly [] Toilets drain slowly [] Wastewater backs up into bathtubs and/or other drains [] Dishwasher wastewater backs up into sink drain [] Odors can be detected coming from drains [] Wastewater detectable in yard [] Plumber or other professional has recommended it [] Other What is the distance of the home from the street?*=_[100]
Either they are on a separate sewer line and connect to the main sewer line later on or they sewerage is pumped by means of a machine into the main sewer line.
Not exactly a sewer main normally flows by graviety and a forced main is a pumped system
The obvious and main problem (and reason to keep your sewer lines clean) is because a backed-up sewer line means that sewage can get backed up into sinks and bathtubs. This is unsanitary and a health hazard. A broken sewage line is costly to repair.
bass
3" house (building) drain allowable. 4" building sewer line needed for house from sewer main.
A little more detail about the sitsuation would help. New construction, remodel, sewer outlet in the house to street or sewer outlet in house to main going out of house.
4" is the standard house sewer main
The two main types of sewer systems are the sanitary sewer system and the stormwater sewer system. They are different because sanitary sewer system has water from sinks, baths, washing machines, and toilets and the stormwater sewer system has water from the rain or melted snow that run off streets and the surface of the land.
This may be an old sewer system probably going to a septic drain field. Before you discard this be sure you have a working potty draining system.
It goes into the main sewer system. It will go through your sewer system and then out to the main sewer. That is if you live in town!