Jeep Cherokee Sport

How do take off the old serpentine belt in a 2001 jeep Cherokee sport?

151617

Top Answer
User Avatar
Wiki User
2006-07-10 20:34:03
2006-07-10 20:34:03

use a 15 mm box end wrench to loosen the bolt which runs through the center of the tensioner pulley - turn it counter-clockwise. next, use a 15 mm socket to loosen the tensioner bolt - again, turn counter clockwise to loosen. remove the belt and replace with new one. turn tenisoner bolt clockwise to tighten belt. tighten bolt through center of pulley. put some belt dressing on and you are good to go!

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

paste this link and it will give you instructions to how to replace belt... http://www.wjjeeps.com/serpentine.htm How do I replace a serpentine belt on a 2001 Jeep Grand Cherokee? Give detailed directions on the belt remove and installation of a new belt.

User Avatar

You can obtain a serpentine belt diagram have most Chrysler/Jeep dealerships. The serpentine belt diagram can also be found at most auto-parts stores.

User Avatar

The water pump is powered by either a drive belt or serpentine belt. Follow the belt and you will locate the pump.

User Avatar

picturediagram of how to install 89 Cherokee serpentine belt

User Avatar

where can you find a free diagram for putting a air conditioning belt on a 2001 Montero sport Mitsubishi?

User Avatar

how do i lossen the belt tensioner on a 2001 Hyundai Sante fe to replace the serpentine belt

User Avatar

how do you change the serpentine belt on a 2001 Rodeo

User Avatar

Put the serpentine belt around the pulleys on your 2001 Chrysler LHS. Tighten the serpentine belt by pushing the tensioner pulley to the left. Tighten down the tensioner pulley and the serpentine belt will be tight.

User Avatar

it is the belt by the alternator belt

User Avatar

they make a serpentine belt tool that you can get at just about any autoparts store to help you remove it.

User Avatar

Loosen the tensioner pulley on your 2001 Chevy Impala. The serpentine belt will become loose. Take the old belt off and put the new belt on. Tighten the new serpentine belt with the tensioner pulley.

User Avatar

If it goes away, then it's probably the air compressor going bad and tying up. check the tension pulley and the serpentine belt.

User Avatar

I need daigram of 2001 ford focus se serpentine belt

User Avatar

its just one serpentine belt

User Avatar

When changing the serpentine belt is it important to have a diagram to make sure the remove and installation are done properly. A serpentine belt for a BMW 2001 540i can be found in the car's maintenance manual.

User Avatar

what are the correct steps to remove the serpentine belt that runs to the alternator on a 2001 Toyota AvalonWas that an ANSWER!? I assume the question is, "How do I remove and replace the serpentine belt on a 2001 Toyota Avalon". (You can remove it with a good sharp knife!)

User Avatar

It has a serpentine belt with a built in tensioner. You can't tighten it. If it is loose, it needs replacing or the idler pulley is defective, or both.

User Avatar

The Jeep Grand Cherokee did not exist until 1993.

User Avatar

I need to know if I need a special to to change my serpentine belt on a 2001 Buick Regal

User Avatar

The 2001 Honda Civic is not equipped with a serpentine belt, but has 2 v-belts. These are tensioned through use of a tensioner.

User Avatar

The serpentine belt goes around all of your pullies in the front of your motor, behind the radiator.

User Avatar

In the belt book at most autoparts stores have a diagram section for serpentine belt routing.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.