PB blaster spray and a vice-grips PB blaster spray and a vice-grips
If it is the pressure line use the appropriate flare nut wrench to loosen and remove the flare fittings, then pull the old hose out and install the new hose. The return hose often uses a hose clamp, loosen the clamp enough to remove the hose then install the new hose and tighten the clamps.
Loosen the tensioner pulley. Remove the power steering belt. Remove the power steering hose. Remove the power steering retaining bolts. The power steering pump will come off.
Loosen the tensioner pulley. The power steering belt will come loose. Remove the power steering belt. Reverse the process to install the new power steering belt.
How does one change a power steering belt on a 1997 nissan pickup?
The 1997 Honda Civic DX did originally come with power steering although you could also purchase models that were stripped down versions. These did not include power steering, power windows, or power seats.
If your Tercel has power steering, use a 14mm socket to loosen the two bolts that secure the power steering pump. Then turn the long jacking screw counterclockwise to loosen the serpentine belt.
If your Tercel has Power Steering, use a 14mm socket to loosen the two bolts that secure the power steering pump. Then turn the long jacking screw counterclockwise to loosen the serpentine belt.
There has never been a drain plug for the Power steering. You will have to loosen a line or suck it out to empty it.
You have to loosen the power steering pump bolts and push down on the pump and the belt will loosen to take it off, to put it back on you route the belt over the pulleys and pull up on the steering pump and when tight tighten the pump bolts and your done.
The 1997 Chevy Cavalier power steering hose is held in place with swivel nuts. Loosen the swivel nuts by turning them to the left. The power steering hose will come off. Reverse the process to install the new power steering hose.
loosen the alternator bolts to get that belt off and the other belt is loosened by loosening the power steering reservoir bolts.
The belt tensioner for the AC/Alternator belt is beneath the alternator. Facing the engine from bumper you can see the ac/alternator belt tensioner on the left side and beneath the alternator. Losen that bolt with size 12 socket. Next, loosen the tensioner bolt until the belt loosens. Now, with the Power Steering Belt you can loosen it by locating the belt tensioner usually found inside of the power steering belt on the power steering pump. Loosen both bolts and if needed pry UP the power steering belt tensioner and the belt should loosen. Repeat until belt comes off. Installation is the reversal of removal. NOTE: You may have to pry down the power steering pump tensioner to tighten the belt.