0
You have to start by removing the top of the center console. Once this out of the way, the bezel will then unsnap from the dash. Use your fingers, tools will just get you into trouble. The bottom of the bezel is the hardest to remove because the floor console is partially in the way. Once you have all of the snaps undone, reaching behind the unit and unplugging the wiring connectors is a little tricky, but it can be done.
I pulled the bezel off to install some switches. You can see the result by following the link below ResponderPSE
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do you remove radio from 2008 odyssey?
how do i remove the radio on the 96 Honda odyssey
How does factory radio in 2008 rav4 come out?
Remove the 2 gray side panels on the left and right of radio using a dash removal tool. There are 4 screws holding the radio in, remove them and set them aside. Carefully pull out the radio and then remove the the antenna adapter and harness from the back of the radio.
Which fuse location controls the radio in the 2008 Ford Explorer?
if there's one when you open up the passengers door then its that one.
How do you remove radio ford ranger 2008?
Go to : http://www.cthreepo.com/blog/2009/09/swapping-the-radio-in-a-ford-ranger.shtml
How do you remove a 2008 Ford Edge Radio?
The radio is removed from a 2008 Ford Edge by removing the control knobs and loosening the retaining nuts. The surrounding trim is then pulled, wiring harness detached, and the radio removed from the console.
How is the radio remove on a 2008 Chevrolet silverado?
From the Service Manual Vol 5 of 5 1. Remove the Cluster Bezel by applying parking brake, move shift lever (automatic) all the way down, tilt the steering wheel to full down position, Gently pull rearward on the corners of the bezel from the instrument panel assembly, remove bezel 2. Remove 3 screws 3. Pull out slightly to gain access to connectors 4. Disconnect the wire connectors 5. Disconnect coaxial cable from radio (Non-Digital) 6. Remove radio Install is just opposite from removal screw tighten to 14 lb in, don't use paint, lube, corrosion inhibitors, locking compound Make sure all clips are in place on the bezel
How do you remove Radio from Mitsubishi lancer 2008?
Here´s the answer..http://forums.evolutionm.net/lancer-how-tos-installations/297464-how-amplifier-installation-remove-radio.html
How many valves does the 2008 Ford Explorer have?
The 2008 Ford Explorer has 12 valves.
What size engine does the 2008 Ford Explorer have?
The 2008 Ford Explorer has a V6 engine.
How do you remove radio in a 2008 Chevy van?
I'm trying to remove the radio to connect two new speakers because the original radio sounds like a 1920 radios and simply I can't. If you already did this please tell me alejandrocozzi@hotmail.com. Thanks and God bless you
Is the 2008 Ford Explorer electric or gas?
The 2008 Ford Explorer is a gas-powered vehicle.
What kind of transmission does the 2008 Ford Explorer have?
The 2008 Ford Explorer has a 5-speed automatic.
