0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you remove the grill from back speakers on a 2007 Chevy aveo?
cut it out
How do you remove or lower the back headrest on a 2011 Chevy Impala?
Hello. I have a 2011 Chevy Impala and the backseat middle headrest prevents good visibility and, thus, is a driving safety concern. Do you have any suggestions? Thank you! Hal
How do you replace the cigarette lighter on a 2002 Chevy Impala?
The 2002 Chevy Impala cigarette lighter is held in place with a retaining ring. Remove the retaining ring and slide the cigarette lighter out. Remove the wiring harness from the back of the cigarette lighter. Reverse the process to install the new cigarette lighter
How do you remove back brakes on a Chevy surrban2002?
how to remove back brakes on a 2002 Chevy surban
Back entry lights do not work bulbs good?
it is a 2001 Chevy impala
How do you get the back seat of a 1976 Chevy impala to fold down?
I don't believe they had that option back in 1976.
Who can install a remote starter in my 2011 Chevy Impala?
you should take it back to the dealer
What is the correct firing order for a 2002 Chevy Impala?
THE ORDER IS 1,3,5 BACK 2,4,6
Where is the EGR valve on a 1995 Chevy Impala SS?
back of the intake manifold ...back of the engine center top
How do you takeout and replace the whole back seat of a 2007 Chevy impala?
To remove the rear seat, pull up on the front of the seat bottom, it should be hooked in place by spring type clips. After you get the front edge up, pull forward and up then remove the seat bottom from the car.This will now expose the bolts/screws that hold the top of the back seat in place. Look below and there should be a couple of screws holding the seat back to the body. Remove these and then you can lift the seat back up and out.
How difficult is it to replace the blend door actuator on a 2007 Chevy Impala?
Pretty difficult unless you have small hands. Under glove box is very tight. Only a couple screws but hard to remove and bolt back in. Would be simple if you could get to screws. I am trying to get mine out now. Anyone have any tips?
Back end banging noise on my 2000 Chevy Impala?
Sounds like you need new struts.
