To remove the back seat in a 2007 Chevy Impala, start by locating the release tabs or bolts at the base of the seat cushion. Pull up on the front edge of the seat cushion to release it from the hooks or clips holding it in place. For the seatback, locate and remove the bolts or fasteners at the bottom and sides, then lift the seatback upward to detach it from the vehicle. Always refer to the owner's manual for specific instructions and safety precautions.
Hello. I have a 2011 Chevy Impala and the backseat middle headrest prevents good visibility and, thus, is a driving safety concern. Do you have any suggestions? Thank you! Hal
cut it out
The 2002 Chevy Impala cigarette lighter is held in place with a retaining ring. Remove the retaining ring and slide the cigarette lighter out. Remove the wiring harness from the back of the cigarette lighter. Reverse the process to install the new cigarette lighter
it is a 2001 Chevy impala
how to remove back brakes on a 2002 Chevy surban
I don't believe they had that option back in 1976.
THE ORDER IS 1,3,5 BACK 2,4,6
you should take it back to the dealer
back of the intake manifold ...back of the engine center top
To remove the rear seat, pull up on the front of the seat bottom, it should be hooked in place by spring type clips. After you get the front edge up, pull forward and up then remove the seat bottom from the car.This will now expose the bolts/screws that hold the top of the back seat in place. Look below and there should be a couple of screws holding the seat back to the body. Remove these and then you can lift the seat back up and out.
It's either in the front windshield or the rear back glass.
Unless it is the Luxury edition, the seats do not fold down.