Want this question answered?
You will need to remove the throttle body and replace the throttle body gasket. The throttle body gasket can be purchased at most auto-parts stores.
it is located in the throttle body. On the bottem. You need to remove the air filter hoses, remove the 4 bolts to the throttle body and then 2 screws to remove the tps.
It is located on the outside of the throttle body in line with the butterfly. Remove the air intake from the throttle body and it will be accessable on the back side of the throttle body. Easier to work on if you remove the throttle body. Easier to clean it too.
It is located on the bottom of the throttle body. You can find the throttle body by following the two big air pipes from the air filter box, they end at the throttle body. To access the throttle position censor you must remove the throttle body.
Disconnect the negative cable from the battery, Remove air filter housing, Relieve fuel pressure, wrap a shop rag around fuel line fitting before you loosen it, Disconnect vacuum lines, electrical plugs, throttle cable and fuel lines from throttle body, Remove bolts holding the throttle body to the intake manifold, Remove throttle body, Remove all of the old throttle body gasket material from both surfaces, Reverse procedure to install.
The throttle plate is inside the throttle body on the intake manifold. The throttle cable from the accelerator peddle is connected to the throttle plate shaft on the throttle body. If you remove the air cleaner hose at the throttle body, you will see the disc shaped plate.
A throttle body can be cleaned without removal. Several spray cleaners for throttle bodies are available at your local auto parts.
On the side of the throttle body opposite where the throttle cable connects. In other words the side of the throttle body facing the fire wall. You will probably have to remove the throttle body itself to replace the sensor as the screws that hold it to the throttle body are vary difficult to loosen.
The Trailblazer has an electronic throttle (drive by wire). There is no IAC valve, it is built into the throttle body. Remove and clean the entire throttle body.
take the bolts out of it
The Trailblazer has an electronic throttle (drive by wire). There is no IAC valve, it is built into the throttle body. Remove and clean the entire throttle body.
does any body out there know how to set timing marks on fiat brava/bravo 1600 1997 on the year thanx martin.