take the transmission out of the car and remove the old clutch, pressure plate, flywheel and throwout bearing/slave cylinder. It can be done with jackstands if they are tall enough. you will need to remove both axles too. there is a video of a 2.0L SPI engine with an mtx 75 transmission getting a new clutch on YouTube, some 'carguy'. it's essentially the same procedure with some minor differences.
I recently did one. The bill was about 1300 dollars. This is because you must replace the slave cylinder with the clutch. This also included fluids and resurface the flywheel.
yes A manual gearbox has a dual mass flywheel An Autobox has a single
To replace the transmission clutch on any stick shift vehicle, remove the engine and/or transmission. The engine and transmission must be separated since the clutch is between them. Pull the flywheel and have it resurfaced. replace the flywheel, following recommended procedures. Use a new pilot bushing/glan nut. Replace the clutch disk using a NEW pressure plate assembly and be certain to align the disk using a pilot shaft. Re-install the engine/transmission in the reverse order that you took it/them out.
how do you adjust a clutch cable in a 2002 kia Rio
how long will it take to replace the clutch in my 2002 renault clio
how hard is it to remove a flywheel on 2002 volvo s80
clutch is same place as any other vehicle between the gear box and the flywheel
i think it may be able to change like with a new flywheel The clutch cable is self adjusting ,do not try to adjust!!!
Tools needed to replace front brakes 2002 Ford Focus?
Hydrolic
It will cost you about $743.00 to replace a vacuum tube on a Ford Focus 2002.
i have fitted a new clutch, clutch fork, flywheel,clutch master & clutch slave cylinders the problem is i cannot get a pedal after bleeding the slave cyl,there is no air in the system & i still cannot get a good enough pedal help????