Want this question answered?
To replace the rear bulb in a Toyota 4Runner remove the plastic covers located in the trunk. Taking off the plastic covers will reveal the taillight housing and bulbs. Replace the bulbs.
check your owners manual the procedure is there as diy
push up and turn on the housing
You need to remove the liner on the trunk lid. That will give you access to the license plate lights housing. Remove the sockets by twisting 1/4 turn and replace bulbs. Size for bulbs are 2825
If you can not remove fasteners on outside, you may need to cut a section out of the inside of trunk to get your hand by the bulbs.
The clear covers for the license plate light bulbs have small arrows pointing in one direction. Simply push the cover to the direction of the arrows and the covers will slide off allowing for the old light bulbs to be replaced.
If your 92 Toyota Corolla taillights are out, but the dash light and fuse work fine, the bulbs could have burn out. Replace bulbs on each side.
Open your trunk the two inner bulbs are for your license plate twist and should pop right out
U need a screw driver, open the trunk and at the latch there is a screw that holds the bulbs unscrew and replace the bulb, u might have to take the inside dash out but is easy to put back on
Do I need rubber like caps on new replaced bulbs in the dash
in the rear facia, under the trunk lid there is 9 bolts holding the facia on. You must remove the nuts and pull the facia out and right above the license is the two bulbs 194. replace the bulbs and put the facia back on and you are on your way.
The lamp in the top brake light of a Toyota Highlander can be replaced by the locating the light housing from the trunk. Find the light cover and remove it to access the lights. Replace the bulbs.