0
What else can I help you with?
How to remove an alternator off a 1986 mr2?
see this page for pictures and instructions: http://www.padandwheels.com/mr2/alternator/alternator.html
How do you replace an alternator in a 1991 Toyota MR2?
unbolt the negative power wire unplug the positive power wore remove the tension bolt on the top of the alternator remove the lower bolt and pull out the alternator
Where is the alternator in a Toyota MR2?
The alternator is located by the right side wheel, at the bottom of the timing belt. It is a difficult process to remove and replace. It must come out the top, so depending on the model of MR2, you may have to disconnect the cruise control and move it aside. You can move it out the bottom but you would have to remove the exhaust.
How do you replace an alternator in an 1987 Cadillac brougham?
Begin by removing the alternator belt. Remove the wiring harness from the back of your alternator. Remove the alternator retaining bolts. Reverse the process to install your new Cadillac alternator.
How do you replace the alternator belt on a 1987 VW Cabriolet?
To replace the alternator belt on a 1987 VW Cabriolet, first, disconnect the battery to ensure safety. Loosen the alternator bracket bolts to allow for tension adjustment, then remove the old belt. Install the new belt by routing it around the alternator and other pulleys, ensuring proper alignment. Finally, tighten the alternator bracket bolts to adjust the belt tension and reconnect the battery.
When the timing belt breaks on a 1987 Toyota MR2 do the valves hit the pistons?
No , the 1.6 liter 4 cylinder engine in a 1987 Toyota MR2 is not an interference engine
How do you replace an alternator belt on a 1987 SAAB 900?
You will need to loosen the alternator belt with the tensioner pulley. When the tensioner pulley is loose the alternator belt will become loose. Put the new alternator belt on and tighten the tensioner pulley.
What is the spark plug gap for a 1987 Toyota MR2?
what is the sparkplug gap on a 1987 toyota corrola?
Where is voltage regulator on 1987 Nissan Stanza Wagon?
In the 1987 Nissan Stanza Wagon, the voltage regulator is typically integrated into the alternator. To access it, you will need to remove the alternator from the engine bay. Look for the rectangular component attached to the back of the alternator, which is the voltage regulator. If you need to replace it, ensure the alternator is properly disassembled according to service manual guidelines.
How do you replace the alternator on a Buick Skylark?
how do you replace the alternator in a 97buick skylark
How do you replace a water pump on a 1987 MR2?
To replace the water pump on a 1987 MR2, first disconnect the battery and drain the coolant. Remove the timing belt cover, then take off the timing belt by loosening the tensioner. Next, unbolt the water pump from the engine block, clean the mounting surface, and install the new pump with a new gasket. Reassemble by reinstalling the timing belt and cover, refilling the coolant, and reconnecting the battery.
How do you change the alternator on a 1991 Toyota MR2?
To change the alternator on a 1991 Toyota MR2, first disconnect the negative battery terminal to ensure safety. Remove the drive belt by loosening the tensioner, then detach the alternator by unbolting it from its bracket. Disconnect the electrical connections, then install the new alternator by reversing the process—reattaching the electrical connections, securing it in place, and reapplying the drive belt. Finally, reconnect the battery terminal and test the new alternator.
