0
It Begins as a series of buttons that need to be pressed and held at the same time. On the Climate Control cluster press and hold the warm button and the off button at the same time. After a few seconds Your check engine light and the light right below it will turn on (they will go off after you are done messing with everything). Then using the "lo" and Hi" buttons you can scroll through the codes that will appear on the fuel management cluster on the left side of the steering wheel. have fun and dont do it while your driving.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
How do you get to the BCM on a 1990 Cadillac DeVille?
behind glove box
What is error code f 85 on a 93 deville?
For a FWD 1993 Cadillac Deville there is no F85 BCM trouble code. There is however an E85 ECM trouble code. ECM codes always have a prefix of E. BCM codes always have a prefix of F. E85 - Throttle body service required (throttle valve not closing).
How do you switch and eprom chip on a cadillac deville bcm?
Pull it straight up out of its socket.
Where is the BCM located on a 1992 cadillac sedan deville located?
Behind the glove box.
What is error code F32 on a 1992 Cadillac Sedan Deville?
F32 - basically what it comes down to is shorted wires between the ECM and BCM, a bad ECM or BCM or a faulty prom or memcal inside the ECM or BCM.
Where is the BCM and PCM on a 1994 deville?
BCM is in the trunk. all the way to the right. You have to remove the panel to get to it The PCM is under the dash on the right side. You have to remove the glove box to access the screw that holds it in place.
If the heater and gas display on a 1992 Cadillac Deville went out how do you fix it?
theese are lit by a 16 volt output from the body control module we often find its a bad bcm.
Where is the bcm located on 95 deville?
It is located on the back side of the rear seat. accessed from the trunk on the passenger side.
Where is the bcm located on a 1990 Cadillac Eldorado?
The best place to start is to look it up in the owner's manual or to search it on YouTube.
Why would the electronic climate control and fuel gauge not work on 1991 deville?
Your problem is that your BCM (body control module) is bad. A used one can be purchased for about $70. To install the BCM, take out ONLY your glovebox. Located right behind the glove box is the BCM, its as easy as unmounting it and unplugging the chord and plugging it into the new one and remounting it. 10-15 fix max.
How do you get ecm code on 92 deville?
I am assuming that you want to get the codes stored in the ECM or BCM that indicate problems. To display stored codes: 1. Turn ignition on. 2. press the "Off" and "Warmer" buttons on the A/C control panel at the same time until all of the warning lights on the dash light up, then release the buttons. 3. Codes will display on the fuel gage to the left of the steering column. 4. .E before the code means that it is displaying a history code for the ECM 5. .E.E before the code means that it is displaying a current ECM code. 6. .F before the code means that it is displaying a history code for the BCM 7. .F.F before the code means that it is displaying a current BCM code. 8. When it reads .7.0. All of the codes have been displayed and the system is ready to perform other diagnostic tests. 9. To Exit Diagnostics, press "Auto" on the A/C panel CadillacMan
Where is the BCM on a 2000 jeep?
It is on the firewall, passenger side, under the hood, behind/above the battery Answer: bcm (body control module) is located under the dash on the left side. remove the knee blocker to access.
