I have a 98 but I'm sure its probably similar. Pop the hood, remove the entire headlight by pulling up on the white pieces of plastic on both sides behind the light, remove the grey cap from, turn the socket with the wires coming out of it, pop the bulb out, and replace!
It sounds to me like your bulbs are out. These bulbs have a lifespan just like the light bulbs in the lamps that you have at home. These are easy and cheap to replace, and you can usually access the bulbs from your trunk, if you own a car.
To replace the turn signal switch of a 1996 Dodge Caravan, open the engine's hood to access the front turn signal bulbs. Then take the headlight assembly a little off the front to give room to get the bulbs. Remove the old turn signal switch and slip the new one in place.
Front signal bulbs on a RSX are changed from the engine bay. Find the lightbulbs for the signal bulbs located towards the bumper of the vehicle. Pull them out and replace them.
Either hand signal or check and replace your fuses and turn signal bulbs.
One of the bulbs is out. Replace it.
Remove access panel in trunk area--Wing nuts should release taillight assembly and bulbs twist out
When replacing the rear turn signal on a 1999 Acura Integra open the trunk. Locate the rear turn signal housings and find the bulbs. Remove and replace the bulbs.
If you're referring to the bulbs themselves, it's very easy. Pop the hood and pull up on the two white plastic tabs behind the headlight assemblies. This releases the entire headlight assembly. Remove the black rubber cover behind the turn signal bulbs and unscrew the turn signal assembly. Once that is removed, you can pull out the bad bulb and replace it with a new one.
For the front turn signal on a Chevy S-10 you remove the parking lamp lenses and replace the bulbs. If it is a rear turn signal bulb the taillight lenses will have to be removed to access the bulb.
One of the bulbs is burnt out. Replace the bulb.
The turn signal bulbs on a 1999 Acura TL are reach through the engine compartment of the car. Find them on the side quarter panels and remove the bulbs from the clips. Replace the bulbs.
You have to remove the instrument cluster to get access to the bulbs.