Want this question answered?
Windshield washer hose is attached on one end to the windshield washer reservoir pump and the other end to the spray nozzles. It is the same as every other car built in the last 50 years. --Ken
The rear washer pump is on the windshield washer bottle, right beside the front washer pump. Take the bottle out of the car and simply remove the old and put in the new.--Ken
It should be inside the windshield washer fluid tank
There is no washer relay.
Assuming that you are asking about the windshield washer tank, it is under the hood, right behind the battery.
They are the headlight washer covers. If you have headlight washers, these covers lift when you activate the windshield washer.
I was under the impression that the first Forester was a 1998 model. Regardless, Subaru uses the same reservoir for both front and rear. Look at the bottom of your windshield washer reservoir and you will see two pumps and two hoses. Rear hose runs along inside the roof to the back of the car. --Ken
The second pump supplies the rear window. Do you hear a pump running when you turn the switch on for the windshield washer?
Begin by removing the hose from your windshield washer pump. Remove the windshield washer pump wiring harness. Remove the windshield washer pump retaining bolts. Reverse the process to install your new windshield washer pump.
Remove the wiring harness from the back of your Chevy Lumina windshield washer pump. Remove the windshield washer pump fluid hose. Remove the windshield washer pump retaining bolts. Reverse the process to install the new windshield washer pump.
The windshield washer pump is located on the firewall in the engine compartment. Remove the windshield washer pump hose. Remove the wiring harness. Remove the windshield washer pump retaining screws. Reverse the process to install the new windshield washer pump.
The windshield washer motor is located on the passenger side firewall