answersLogoWhite

0


Top Answer
User Avatar
Wiki User
Answered 2007-01-31 20:09:29

The master cylinder is located low, on the bulkhead (firewall) You can see it if you look under the hood, but you have to look carefully if you aren't familiar with it. It's very difficult to add fluid to it without a long funnel.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Loading...

Related Questions

How long do front brake pads last on a 2009 Chrysler Town and Country minivan?

Sorry, I do not have an answer for you, but I am having the same problem with my 2009 Chrysler Town and Country. 24,000 and I need new brakes. What a joke. This will be the last car I buy from Chrylser.


How do you change the bulb in the third brake light on a 2008 Chrysler town and country limited van?

Which model of chrysler van? Resubmit the question with make, MODEL and year.


Where do you add brake fluid on a 2001 Chrysler Town and Country Limited?

Brake fluid is added to the brake master cylinder, under the hood on the driver side, back near the base of the windshield.


What type of brake fluid should be used for a 1998 Chrysler town and country?

A 1998 Chrysler Town and Country uses DOT 3 brake fluid.


How do you add brake fluid to a 1998 Chrysler Town and Country?

It is important to keep brake fluid in a car. Brake fluid is added to a 1998 Chrysler Town and Country, under the hood into the reservoir labeled 'brake fluid'.


What should you do if you accidentially put about 1 oz of brake fluid into the power steering reservior of a 2000 Chrysler minivan?

This small amount will do no harm.


Where is the brake switch on a 2003 Chrysler Town and Country?

The brake light switch is above the pedal.


What type of brake fluid is used in a 1996 town and country?

A 1996 Chrysler Town and Country uses DOT3 brake fluid.


What brake fluid for a 2008 Chrysler Town and Country?

Dot 3


What kind of brake fluid do you use for a 2001 Chrysler Town and Country van?

A 2001 Chrysler Town and Country uses DOT 3brake fluid.


What kind of brake fluid for a 1997 Chrysler Town and Country?

Dot 3


Why would the front left brake on a 1996 Chrysler Town and Country become extremely hot?

Failed caliper or brake hose.


Chrysler Town and Country emergency brake light on?

Red brake light most likely on due to brake fluid level/sensor issue or parking brake on/wiring issue


What is the correct brake fluid for a 2002 Chrysler Town and Country?

The proper fluid is DOT 3.


What type of brake fluid is used for a 2000 Chrysler town and country van?

Dot 3


What is the cause of a soft brake pedal on a Chrysler town and country?

most likely it is air in system


Where do you add brake fluid on a 2005 Chrysler Town and Country?

Under the hood, driver side, rear.


How much should front end brakes cost on Chrysler Town and Country?

The price of front end brakes on a Chrysler Town and Country varies by the quality of the brake, the more expensive the better the brake is. A very good set of front brakes will cost around $75. 00.


Do you compress rear disc brake caliper on a 2005 Chrysler town and country van the same as the front?

Yes.


Where do you add brake fluid to a 2000 Chrysler Grand Voyager Minivan?

At the master cylinder... its located to your right as you pop the hood... just take the lid off and fill it up... Dont press on the brake while the cap is off or else you will be filling the brake system with air, and that means you will end up having to bleed the brakes.


How do you retract the rear brake piston on a 2008 town and country?

Compressing the rear brake caliper piston on a 2008 Chrysler Town and Country requires a special tool that pushes in and turns the piston at the same time.


Can brake fluid be used in stead of power steering fluid in a chrysler town and country?

No but you can use atf,trany fluid


Chrysler Town and Country brake lights not working?

check fuses if no luck check the brake pedal switch down under the dash by the pedal or check for a loose ground


How do you change rear brake light 2000 Chrysler Concorde?

Brake light, on your 2000 Chrysler Concorde, by accessing it from the inside of the trunk. Take hold of the brake light, push in and turn. The brake light will come out.


Where is the brake light switch on a chrysler sebring?

On the bracket the brake pedal mounts to.