Ford makes a adaptor block that will allow you to add hydraulic circuits to the tractor. If you only need one or two circuits you can get a set of control valves that will mount in place of this block. Both will mount just under the front edge of the operator seat. Be warned the pump on the 4000 doesnt move a lot oil and the circuits may be slow. Other wise you can add a pump to the front of the engine or to the PTO on the rear. The front pump should be available from ford. The PTO pump is available at a lot of after market locations.
4800
Parts for a Ford 4000 tractor parts come in three forms. Used parts are available from Broken Tractor. Restored parts can be found through Tractor Part. Finally, specialty welders and tractor supply stores offer newly made parts that fit the 4000.
4o to 55
The level check for the hydraulics/transmission/rear axle is pipe plug on the left side of the tractor just in front of the rear axle housing. Oil is supposed to be at that level with all hydraulics extended.
behind the foot rest left under the pto handle
dip stick check it
I got mine in the ford tractor 3000 repair manual i bought at the tractor parts store for about 24.00. Beware that Ford used a whole bunch of carbs on 3000 and 4000 models over the years. I also found a tractor parts/ repair store that would send off my carb and have it rebuilt for about 90.00 in 10 days, not bad...
Because you have probably hit the engage lever with your left heel getting on or off of the tractor.
Under the operators station on the right side in front of the rear axle. It is a long spin on filter.
how do i dismantle a power steering gear box
The power takeoff on a Ford tractor is designed to operate equipment like plows, winches, and mowers. It uses the power of the engine to readily run accessories.
in the bottom of the sump under the seat.You have to split the tractor in 2 at the transmission to change it.Good luck it about a 6 hour job