Want this question answered?
There's not enough air (oxygen) in the gas-air mix. Often gas stoves have an adjustment that allows you to adjust the mix. Adjust the mix until the flame is entirely or almost entirely free of yellow.
The fuel system on a Briggs and Stratton engine works by fuel being gravity feed from the fuel tank. Fuel goes to the carburetor where air and gas the mix, after the air and fuel mix it is feed into the engine where the engine goes through the four strokes.
VERY likely your fuel mix is too lean. Adjust the air/fuel mix settings and it should fix it.
If you have fuel coming out of your air filter, then your carburetor bowl float is most likely gummed up an stuck. try tapping on the bowl, or you my need to take it off an clean it and the needle jet. How do you adjust air/fuel mix on a lawn mower motor?
engine is possibly running on too lean a fuel-air mix, should be a little screw on carburettor to adjust fuel-air mix.
It should be someplace on the air intake that goes into the motor with 4 screws holding the cover on . At least that's where it is on my Mustang my Mass air flow module is
Behind the glove box, above the blower motor.
That engine has an EFI (Electronic Fuel Injection) system. There is no adjustment.
The intake manifold in a motor is like the lungs of your car. Air is taken in through the intake manifold and then is evenly distributed to the cylinders to mix with gas.
any number of things - clean the air filter, adjust the timing, increase the fuel mix, decrease the fuel mix, check the plugs, check the carb - could be lots of things best take it to a garage
Mix air,heat and fuel.
Yes