Want this question answered?
how do you change the handbrake cable on a 1997 Toyota rav4
underneath the front cable runs to the back onto the left and right , the nut is there
i dont no
Cable underneath has a nut(s) to adjust.
change hand brake cable citreon relay
How do you remove handbrake cable from brake caliper 3litre signum right hand side
change hand brake cable citreon relay
the handbrake cable splits into two under neath the car. To adjust the handbrakes, alter the adjusting bold ratio at the bottom and on both sides of the car.... You can also remove the cover off the handbrake cable and tighten to size 10 bold that links the cable to the mechanisim inside the car
It is very easy to adjust the handbrake on a Vectra C. All you need to do is remove the rear console and release the handbrake. Under the handbrake is a cable with a white end fitting, push down the end fitting onto the plastic locking device. Then pull the lever and it will be adjusted.
If there is a chance the normal brakes may not work properly to stop the vehicle the handbrake cable on the rav4 2002 needs to be changed. Adjust the emergency brake, or handbrake, using a wrench or screwdriver. Turn until the brake line becomes tighter.
If it has rear drum brakes, it's under the car, where the handbrake cable emerges from inside the car. If it has rear disk brakes, there is addition adjustment inside the rear disks on the handbrake shoe mechanism. This adjustment should be carried out before attempting to adjust the cable.
Remove plastic cover on handbrake lever. You will find an adjustment nut plus a locknut on each cable, as there is a separate cable for each side of the car. Adjust as necessary.