0
How do you adjust hi and low settings on a Homelite 330 chainsaw carb?
Wiki User
∙ 13y ago
turn both hi and low fully clockwise till seated. then turn each 1 full turn counterclockwise then adjust your idle speed with idle set screw.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
How do you adjust carb on 330 homelite chainsaw with 3 screws?
The carburetor on a 330 Homelite chainsaw can be adjusted with the 3 screws. Turning to the right increases the richness or gas flow. Turning to the left increases the air into the mixture.
What are the carb settings for a 020AV stihl chainsaw?
turn in then 1 1/4 turns out on high and low factory settings hope this helps
McCulloch chainsaw carb adjustment?
The carb on a McCullouch chainsaw can be adjusted by turning the idle mixture screws. This controls how much fuel and air are mixed inside the carburetor.
How do you adjust carb on 97 Polaris 400 4x4 2stroke?
Adjust carb on 400 Polaris 4x4 2stroke
Why would a 305 tbi run lean?
Too much air to fuel mixture with your carburetor, adjust the carb settings to allow for more fuel to enter the chambers.
1984 Mercury topaz has a high idol how do you adjust the idol?
"84 is still the carb. There is a small screw right at the throttle cable on the carb. Adjust that.
How do you adjust the carb on a 2000 Honda xr100?
there is a screw on the carb. be sure to adjust while the engine is running so you can tell by the idle when it is set properly.
Honda 200s carb adjustment?
Factory carb settings for a 84 Honda 200s
How do you adjust the float on a Chevy 1970 Rochester carburetor?
Bend the tab that contacts with the "needle". But DON'T put pressure on the needle when you do so. Carburetor rebuild instructions that come with the carb rebuild kit will tell you how to adjust everything and give optimum float level settings.
How do you adjust idle speed on 1983 Monte Carlo?
there is a set screw on the linkage on the carb that will adjust it.
What is the routing for the fuel lines on a Poulan 3400 chainsaw?
Fairly simple. Fuel line up from tank.....underneath carb.....to right side of carb inlet fitting.
Weber carb and its running too rich how do you adjust carb for an 87 samurai?
it's the screw right above the mounting bolt on the left rear of the carb. you'll have to adjust the idle screw as well as you lean it out. then check your timing again
