Take it to your nearest certified Kawasaki dealer...
You can adjust the governor, on your 550 Kawasaki Mule, by increasing the fuel to the carburetor. The fuel adjustment screw is on top of the governor.
You need a special tool from Kawasaki to hold the drive pulley. The Kawasaki part number for the tool is 57001-1520. After you remove the convertor cover. You remove the drive pulley by bolting the tool on the three upper bolts then take off the drive pulley nut (left hand threads). Once the pulley is off take the belt off the driven pulley then you can reinstall the new belt. You also have to check the belt deflection. Put a straight edge from the belt on the drive pulley to the belt on the driven pulley. Using a ruller push down on the belt. The deflection should be no more than 1". If it is I would take the ATV to a Kawasaki dealer. They will need to add or subtract springs and shims from the drive pulley. If the old belt has never been change you might be OK by just replacing it. I have not tried to take the drive pulley off without using the special tool from kawasaki. The best thing you can do is go to RepairManuals.com and look up a KVF650 2003, you can buy the OEM repair manual for $60.00 plus about $6.00 shipping. It has saved me a lot of money.
Adjusting the drive belt on a Kawasaki Mule requires a specialized tool only available to dealer mechanics. The belt should have no more than one inch of deflection when pushed down. Any more will require adjustment of replacement. Replacement can be done by removing the converter cover. Disconnect any wires that may be (with some models) present. Remove the drive pulley and belt. Replace belt and check for deflection. If more than one inch is present, shims will need to be added or subtracted, which requires a dealer.
If its on a golf cart or mule email me at gibsonvillepaul@yahoo.com and i will be glad to help you
how much for Kawasaki mule 3010 with 170 hrs
How do u make a kawasaki mule 1000 go faster
How do you remove the starter selinoid on a kawasaki mule 550, 2000 model
The wiring diagram, of a Kawasaki Mule, 550, can be obtained from most Kawasaki dealerships. The wiring diagram can be purchased at most auto-parts stores.
When changing your battery on your Kawasaki mule, it is best to take careful precautions. To ensure that you have the proper procedures and location, seek the advice of a certified Kawasaki mechanic.
The recommended type of oil to use for a Kawasaki 610 Mule is API SF. Th610 Mule will hold approximately 1.5 quarts of oil.
You open the hood on the front of the mule and it will be on the left side
You'll need the snowblower, the mule drive for the snowblower, and the belt off of your mower deck. The blower attaches where the mower deck mule drive snaps in with the two spring pins. The mule attaches to the bottom of the blower and back to the deck height adjustment hookup. Run the belt from your PTO, through your idler pulleys on the mule, then round the drive puller on the blower. Tension the belt and you're off. Case tractors are beautifully simple.