Since this is an HOB, the flow can only be adjusted by cleaning (increase) or adding media (decrease)
You can adjust your VW carburetor by using the adjustment screws. There is an adjustment screw to adjust the flow of fuel. There is an adjustment screw to adjust the flow of air.
no. there are no adjustments on any mass air flow sensor
Lights when the gas flow is small and only then adjust the flow from the source as desired. Also adjust the burner with the rotating the barrel.
If your goldfish is being blown about by the current created by the filter then the fish is either playing in the current deliberately, or the current is too strong for the tank size. Most filters can be adjusted to increase or decrease the amount of water flow. If necessary you can decrease the amount of water flow.
tell me how to adjust the air flow.
air flow is toward floor. blower is below filter. blower pulls air thru filter.
no, The carbon in your filter can only take in so much. it must be changed when the water flow is restricted. only do 10% water changes at a time .
That completely depends on the filter and the condition of the filter. It can range from <5 gallons per hour to more than 1000. If detritus has accumulated in the impeller or the intake then expect much less than the manufacturers quoted value.
Flow Max is a filter so I would say no.
Normally you don't really need to clean the filter unless the flow is too low. If this is the case, you will want to rinse any filter media in a clean bucket of old tank water. Do not rinse filter media in tap water as this will kill off all your good bacteria for your tank.
You should be able to, but make sure that the sand filter with the slower flow rate is on top to make sure that the other filter does not overflow. If you place the faster flow rated filter first then slowly the slower one will fill and eventually overflow.
the air flow from the filter or it might be inturnal