0
How do you adjust the two control springs under the hood of a 1993 Buick LeSabre to slow the engine down?
Wiki User
∙ 19y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you reset the engine control computer on a 1999 Buick Lesabre?
If you are referring to resetting the Check Engine Light then you will need to have someone with a scanner to do it. If you are referring to reprogramming the Engine Control Module then the dealer will do it.
Why does my 1994 3.8 lesabre engine runs rough at a light throttle and on cruise control?
check for vacuum leak.
Adjusting lifters on a 5.7 Chevy engine?
If they are hydraulic, they should never need adjustement. if not, you adjust lash between arms & springs.
How do you adjust the idle on the diesel engine?
This question is not answerable without make model year and control system for the engine.
How do you repair the cruise control on a 1994 Buick Lesabre Limited?
First you need to troubleshoot the 1994 LeSabre cruise control. Check the fuse, the cruise switch, the linkage, to find where the problem is. Check the vacuum lines on the engine as a vacuum leak can cause the cruise to not work properly.
How do you adjust the idle on a 1993 Chevy 4.3 liter vortec?
The idle is control by the idle air control motor from outputs from the Engine Control Module.
Does a knock sensor have to be replaced?
Yes, it helps the engine control computer monitor and adjust the timing
Is the pcm and ecm the same thing in my 2000 Buick lesabre?
Yes the ecm( engine control module)/ pcm( powertrain control module) are the same thing. Different manufacturers use different acronyms, ECU (engine control unit) is another often used.
How do you adjust the idle on 1992 Chevy s10 blazer?
You don't, it is done by the ECM (Engine Control Module).
Where is the ecu located on a 1995 Buick lesabre?
where is the engine controle module located in a 1995 buick lesabre
How do you adjust the engine speed on a 1993 Buick LeSabre?
you have to adjust the Idle position sensor on the throtle body,it has two small cap screws ,you loosen them and turn the sensor and tighten the screws when you reach the idle speed you want.the motor should be warm so you'll get the idle you want.make shure it's not to slow or the engine will die when you put it in gear.
What are the torque specs for the rocker arm nut in a 1998 Model 5.7 Liter engine or do they have be tightened all the way down with no pressure on the valve springs?
you adjust while it is running
