Had that problem 02.25.09 & fixed the problem. On the firewall you will find a plastic compartment which houses the motor and arm assembly. The cover is plastic & has three snap connectors. Mine was FULL of dirt & leaves & other junk! After cleaning out all the junk not suppoed to be there, my wipers now park in the down position as they are supposed to. I did spray a little WD40 on the moving parts as well.
Turn the wipers off, pull the wiper arm off, and replace it in the correct down position.
You can use a safety pin to do it.
You pick up the wiper blade as far as it will go WITHOUT forcing it-Look where IT connects 2 the piviot (OR) car-there is a very small lever @ the base-PULL it AWAY from the Piviot POINT (car) maybe 1/2 inch & let the wiper back toward the windshield-when it stops wich will be B 4 it touches the windshield - U will B able 2 POSITION the ARM whereEVER U want. If the wipers are not parking correctly, you may simply need to replace the wiper motor. The wipers park when the motor runs backwards after the main power is cut off, and sometimes the switch gets broken inside the unit.
how to adjust the trottle position on a 1999 kia sportage
No adjustment is possible.
You must remove the arm of the wiper and move it down
yes
what year?
Remove windshield wiper linkage shaft to arm retaining nut cover. If necessary, turn the ignition ON then turn ON the wipers then OFF to bring them to the park position. Loosen and remove the nut which holds on the arm. Remove the arm and adjust it to be parallel with the bottom off the windshield. Put the arm on the shaft turning it to line up with the splines on the shaft. Replace the nut and the cover and test
Slide it in or out to adjust the tone quality, also adjust the position of your flute.
You can only adjust the clutch pedal. You can adjust position and range just on top of the pedal.
Your windshield AND wiper blades a good cleaning. if the blades are a few years old, replace them.