Well if you pop the hood and look above the headlights you will see a screw. It may be a hex screw. Now if you need to raise the lights tighten the screw and if you need to lower the lights, loosen the screw.
Specify what you mean.
there is no adjustments on the headlights.
try turning the screws that are located by the headlights usually on top.it should have two per headlights 1 horizontal adjust and 1 vertical adjust turn them slowly until you find your desire aiming spot.(check you vehicles manual for manufacturers specs)
uses a bubble level to aim the headlights.
Take it to the dealer and let them put there gauges on them to get them set right.
There are little black rods sticking up by the head lights that have a spot to put a screwdriver in. You turn these rods to aim the headlights correctly.
Park your vehicle approximately 15 feet from your garage door or another wall. Open the hood and on top of both of the headlights you will see adjustment screws. Rotating them will lower/raise the headlights
The are adjustment screws next to the headlight housings. To adjust the headlights either loosen or tight the screws. This will either raise or lower the headlight unit.
You need special equipment to do this correctly. Take it to a dealer for this.
Take it to a dealer or a good body shop. You do not have the proper equipment to do this correctly.
To aim the Mitsubishi Galant Headlights open the engine compartment of the vehicle. Locate the headlights and use a screwdriver on the vertical adjustment screw positioned on top of the headlight. This screw will allow adjustment for position where the light will shine.
There are 2 screws on the assembly. The center one is for aim adjustment.