Some use straight pins into back of connector or a tester that will pierce the wire so you can probe while it's plugged in.
The Toyota Tacoma throttle position sensor is adjustable. There is an adjustment screw on the back of the throttle position sensor.
It is on the side of the throttle body should be on the back side.
In the back of the Throttle Body right side for 94 accord DX.
P0122 - Throttle Position Sensor circuit low input. P0123 - Throttle Position Sensor circuit high input. Change your TPS(Throttle Position Sensor). It is located on the driver's side of the throttle body with a three wire connector, usually white. If you need instructions, reply back.
The throttle position sensor is on the back of the carberator. Held in with two star bolts. Unscrew them and put your new sensor into place. Note the position of the old sensor. very tight space. little room to work. but its managable without removing any other parts.
The TPS sensor is under the black air intake on the throttle body. It is generally located on the back side of the throttle body facing rearward. On a select few models, it will be on the driver side of the throttle body.
tps is back of throttle body look where your throttle cables hook up in the front look on the back side of that it has two harnesses that plug in
try changing the throttle position sensor
The TPS (Throttle Position Sensor) and several other sensors feed information back to the ECM (Engine Control Module) so the ECM can make adjustments to keep the engine running at its peak performance with minimum emissions.
its behind the coil packs on the back of block
Hi, The Throttle Position Sensor is located on the back side of the throttle body, towards the firewall of the van. You may have to remove the big air intake hose to get to it. You should see three wires coming out of the electrical connector to the sensor. The colors are Black, Gray, and Dark Blue. If you find that connector with those 3 wire colors, you have found the sensor. Good Luck, Greg
Perhaps throttle plate (in throttle body) is sticking Also could be the throttle position sensor or the idle position sensor and could be the throttle cable --if you have used any fuel enhancers it gums up the throttle position sensor and it will stick. Had the same issue with 1996 -its the senors in your transmission-has 2 -need to put on diagnostics for which is causing it and then to replace parts -approximate cost for for part 60.00 cad -labour 1200.00 to 1600.00