Shut the water supply to it and drain it.
I would be curious to know the answer to this question also so I hope someone who knows something about the subject answers soon.
bleed the air tank by pushing down on the air stem, remove the pressure from the water tank,add correct amount of air to bladder, then start pump.
Hot water tank needs bleed of air,
You must drain the tank almost to bottom, switch off the pump and water feed to house . Now put in 27-28 psi of air if you have a 30/50 pressure switch. Put in 37-38 if you have a 40/60 switch. It may be necessary to adjust the pressure switch after observing cut in and out.
When your house is fed by a pump, it is fed into a water tank. That tank has a layer of air under pressure on top and water underneath. When you turn on a faucet, the air pressure forces water through your faucet. When your water pressure gets low, the pump turns on. Then the pump fills up your tank. Every now and then, the tank loses all its air and gets completely full of water. When that happens, you hear loud hammering. Then you have to bleed the tank by getting rid of all the water in it. You save enough to clean it. Hopefully, you can find the directions that came with it. If you can't, here is a procedure that has been used. You shut down the electricity. You drain the tank. You clean it out. You get rid of the gunk that built up. Then you close it up. You turn on the pump. The water that runs in compresses the air in the tank. That will give you the water pressure when you turn on your faucet before the pump kicks in.
Needs more explanation - you may be referring to a well pressure tank, if that's the case -say so ! Give us as much information as you can if you expect a good answer.
If it has a bleeder then you bleed it.
how do I bleed water system on the 806 peugeot
no its supposed to be clamped down, and its not a bleed tube its an air vent
Bleed of oxygen tank upside down and bucket of water when all pressures released but it in a vise Take monkey wrench and cheater pipe and get down through there
you should unhook supply line and return fuel line from back of head this will bleed fuel from head. to bleed entire fuel system unhook fuel lines at fuel tank be sure to plug fuel tank or you'll loose all your fuel in tanks.
no it stops in water.