To bleed the brakes you have to:
1. Fill the master reservoir full with brake fluid.
2. Start with the RR wheel, then LR wheel, then RF wheel and last LF wheel.
3. Put a length of clear hose onto the bleeder valve nipple.
4. Place the end of the hose into a fluid container, like a clear glass bottle.
5. Have an assistant pump the brakes up and then hold it to the floor.
6. Keep the master cylinder reservoir full while doing these steps.
7 While they are holding the pedal to the floor open the bleeder valve and watch for bubbles in the hose going into the clear glass bottle. Before they let up on the clutch pedal close the bleeder valve.
8. If there are bubbles in the clear container repeat the process again having the assistant pump the pedal, then hold it to the floor while you open the bleeder valve to check for bubbles.
9. Keep doing this until you get no bubbles. Always start with the wheel that is furthest from the master cylinder first going to the wheel that is closest to the master cylinder.
9. Do this on all 4 wheels.
How do you remove the rear drum brakes on a 1998 ford escort
show 1993 ford escort ac diagram
it all runs off of your brake fluid, gotta bleed the slave too like brakes ray
bleed it the same way u bleed the brakes
With years of experiance
The timing chain for a 1993 Ford escort is located on the front of the engine. It is under the timing chain cover.
The 1993 Ford escort did not come with an EGR valve. It is one of a few year models that do not have one.
The firing order for a 1993 Ford Escort LX with a 1.9 engine is 1-3-4-2
AnswerGo to the link for a full brake job with picture illustrations of each step and it is for 1997 ford escort.
see answer for 1993 escort
Very carefully
The type of vehicle is not important, but if brake pressure is failing, you need to bleed ALL the brakes.