Saw into it twice - cutting out the space needed for a new "T" then insert the "T" and the packing and lead it up.
A vent pipe which is the continuation of a SOIL STACK which means a toilet is drained into it versus a waste stack that is continuation of a grey water drain.
Install a ty fitting on the stack in the basement then run it to the sink. Put it low enough to account for a fall in the pipe, to allow proper drainage. Be sure to install a waste and vent pipe to code for both fixtures.
//made by vijay sahu#include#includevoid main(){char p[20];int stack[15];int ts=-1,top=0;int l=strlen(p);coutp;for(int i=0;i=48 && p[i]
It really depends on a few things, where the clog is(is it in the toilet itself or in the "stack" below the toilet that runs into the sewer system and what is causing the clog. For lack of a better way of saying it, if it is toilet paper or a large #2 then a plunger will usually do the trick. For really stubborn clogs you could use a toilet auger, just pay attention not to damage the finish on the toilet bowl.
A double stack system is where you have the main soil stack to carry away toilet waste (Generally). With a separate pipe taking waste water from a Shower/Bath/Basin to an outside gully leading to a sewage drain (maybe via guttering on your property). Not a common system on new builds but still found on pre 60's plumbing.
in the kitchen cabinet
As long as there is a cleanout on the stack, 25 feet
Which code ? there are several out there
A vent pipe which is the continuation of a SOIL STACK which means a toilet is drained into it versus a waste stack that is continuation of a grey water drain.
WASTE STACK or VENT STACK?
Most of the time they are. Depends on how far of course. Usually, the toilet is by the main stack so it only has to go the 12 to 16 inches to get to the drain. The main stack goes through the roof for the vent for the whole house or the bath and laundry. As long as the toilet is getting venting from somewhere, it should still flush.
The toilet is 3 or 4 inch and the shower is 1 1/2 or 2 inch. You could reduce the toilet to 2 inch, but it would never flush correctly or be of much use. The current toilet drain has no trap in that section because one isn't needed. The toilet itself is the trap. If you are using existing waste lines, they should already be connected to the vent stack. If you are adding lines, connecting to the existing stack is fine as long as it is above the last drain.
The toilet will gurgle as it sucks air through out the toilet trap. You may even hear it suck air through a nearby sink or the tub. Sometimes it may just drain slow or weak.
//made by vijay sahu#include#includevoid main(){char p[20];int stack[15];int ts=-1,top=0;int l=strlen(p);coutp;for(int i=0;i=48 && p[i]
Install a ty fitting on the stack in the basement then run it to the sink. Put it low enough to account for a fall in the pipe, to allow proper drainage. Be sure to install a waste and vent pipe to code for both fixtures.
a stack is when the offense or defense line up vertically or horizontally and then break off in separate directions in order to catch or block the disc
yes go to google and search "smash stack instructions" trust me, i have 4.3u and used smash stack. it works on every wii firmware.