Want this question answered?
Depending on the transmission type, the neutral safety could be located in several places on the transmission. If the switch is bad, the Rodeo could either start in any gear, or not start at all.
On the transmission. I is hooked up to your shifter. Be careful replacing this part. It will strip out easy and be no good.
No
This is a safety issue but if you do it just connect the wires together.
bypass key on a trooper
According to the wiring diagram, there is no inertia switch. There is only a relay switch in a 1991 Isuzu Trooper.
Switch to TOD and drive about 5mph. Once all 4 tires light, switch to 4H while rolling slowly and in neutral. Might have to step on brake?
how to remove lock cyliner switch 1988 Isuzu pickup
Where is the fuel cut of switch for a 03 isuzu trooper
It is a neutral switch.Starters on newer Isuzu will have a safety-switch installed, even for manual transmissions. The switch, inside the transmission or clutch, will disable the starter circuit until the vehicle is in the proper "mode" to engage the starter.For automatics, this means the starter won't engage unless the transmission is in Park or Neutral.For manuals, (stick-shifts) this means you must engage the clutch while turning the key. Until you engage the clutch, it will seem like the starter is dead.You can have a look at the related link for some trouble shooting pointers.The safety-switch(called a Mode switch for AT) is on the side of the transmission and the clutch switch is on a bracket in front of the clutch pedal. It is activated (switches on) once the clutch pedal is depressed.
Isuzu trucks have a 2.5 out of a 5 point scale for safety. This is for the 2004 model. They lack in airbag location but are good for accidents from behind.
How I can replace ignition switch cylinder from Isuzu Rodeo?.