0
How do you calculate 45 degree steel elbow weight-- need a formula?
Wiki User
∙ 12y ago
The easiest way is to find the centerline length and multiply that by the linear weight of the pipe size being used.
Alternatively, this formula should give the weight of an elbow in pounds:
w=0.071*pi^2*R*(ro^2-ri^2)
Where:
w= weight of elbow (lb)
R=curve radius of elbow (in)
ro=outside radius of pipe (in)
ri=inside radius of pipe (in)
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
What is minimum bend radius for a pipe?
45 degree, 90 short radius degree ,T ,elbow,cap,concentric reducer, Tee and flange
Can you weld a slip on flange to a 90 degree elbow?
Sure why not its the same as welding it to a straight piece of pipe
What is the difference between long radius and short radius elbow?
In the area of industrial pipe fittings: Long radius 90 deg elbow has a take off dimension of one and one half times the nominal diameter of the pipe. Ex-4 inch pipe has an actual diameter of 4.5, for the elbow the take off dimension would be 4"*1.5=6". The short radius elbow take off dimension is the same as the nominal size, 4". To add to the point, a short radius elbow can be used typically where space is a constraint. Hence fluid flow is also restricted in this case unlike in case using of Long Elbow.
Where on your arm would you find the fulcrum?
The elbow in the hand is analogous to the fulcrum in a lever
What are the 7 flexible joints in a robot?
elbow neck shoulder feet knee finger nose
What is the formula to calculate surface area of a 90 degree elbow?
The formula used to calculate the surface of a 90 degree elbow is pi^2 *. This formula is taught in geometry class.
How find the 90 degree elbow center?
How to calculate 90 degree and 40 degree elbow center >For 90 degree elbow(Dia*38.1) this formula used for only 90 degree elbow. >For 45 degree elbow(45/2of tan*Dia*1.5*25.4) this answer obtained in (mm).
Formula for calculating 90 degree elbow?
The formula for calculating the 90 degree elbow is W+R*2*3.14/4*P=Meter Square . The area is computed by using the formula (W+R)_π/4_P.
What is the formula 45 degree elbow?
15.875 x pipe size=
What is a formula to find center of an 90 degree elbow?
Measure 45o
What is the take off formula off 45 degree elbow pipe?
The take off formula of a 45 degree elbow pipe, will depend on what the pipe is on. Sometimes a 45 degree pipe will need a 90 degree right angle turn to come off.
Do elbow 135 degree and elbow 45 degree are same?
No, elbow 135 degree and elbow 45 degree are different from each other.
What is the formula for determining the takeout of a 45 degree Elbow?
5/8 x pipe size
How to calculate Length of long-radius elbow?
how to calculate the elbow radius or elbow length
What Formula for long radius 45 degree elbow?
1.414. x offset- Straight of 45's
What is the Pipe fitting formula for 45 degree elbow?
1.4142 will give you the travel piece C-C then you deduct for the fitting
How do you calculate surface area of pipe elbow?
(Pi*(Center of elbow - od/2)^2-(pi*(Center of elbow+od/2)^2)÷4)÷100000=0.221 Square Meter
