this can be calculated by measurements of the bore
The teves caliper is a single piston disc brake caliper and the akebono caliper is a dual piston disc brake caliper. The teves caliper is a single piston disc brake caliper and the akebono caliper is a dual piston disc brake caliper.
If it is the front brake use a "C" clamp to retract piston If it is the rear and the parking brake is used by this caliper piston is threaded and a special tool (not expensive) available at Sears or auto parts to "screw" piston into caliper body
Hydraulic force, transmitted by the brake fluid.
You can use a large C-Clamp to compress the caliper piston.
The piston is forced out of the caliper by the pressure of the brake fluid. This pushes the brake pads against the rotor, in turn stopping the vehicle.
Remove caliper mounting bolts Slide caliper off rotor Use a "C" clamp to fully retract piston into caliper body If parking brake is used on this caliper piston is threaded and a special tool (not expensive) is required to thread piston into caliper body
Yes, there is such a thing as twin-piston calipers.
You probably have frozen brake caliper slider pins or a frozen brake caliper piston on one side.
Clockwise to retract piston into caliper body
You have to have a air compressor to do it. Take an air gun and insert it in the hole on the caliper were the brake line goes to it. Then take the piston in one hand and start it in the caliper while you are blowing air into it and the air will push the rubber boot out around the piston as you push the piston in. It is alittle trickey, But that's how you do it.
Yes, you need to remove the caliper first, then use the old brake pad and a C clamp to push down the piston of the caliper.
replace brake hose they colaspe