0
how to maintain hardness of wire ,before zinc polish or we can maintain after zinc polish.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Why does my 1983 Datsun 280zx die whenever it rains It does not want to start or when it rarely does start will not stay running just dies no spit or sputter but only when it rains?
You need new wires, or distributor cap. Moisture can get into a cracked cap or cause wet wires where spark jumps from wire to wire, or wire to ground.
What is the defects that take place in deep drawing?
In deep drawing process the following defects may occur: 1. Wrinkles - caused due to excessive clearance between the punch and die. also caused due to improper pressure pad pressure and die and punch radii, 2. Ruptures - caused by incorrect draw ratio another reason is improper die and punch radii, 3. Excess thinning of the cup wall - caused by incorrect die and punch clearance and radii and also excessive pressure by pressure pad. These are the most typical defects. Hope the above helps.... Keshav Udipi
What would cause an engine to die every time a car stops?
Could be fuel or electrical problem. Does the car start and run okay the first time you start it? Does the engine run smoothly under load?
Who is Poul Beckmann?
Poul beckmann is famous for drawing bugs and living jewels. Poul beckmann was born in 1949 in Copenhagen ( Denmark ).
Why did my 2008 Nissan sentra se's starter selanoid just die and is it hard to replace?
a solinoid is nothing but a relay... (it is a coil) when you put potential through it it causes an electromagnetic field causing contacts to change.. the only thing that will cause it to *die* is a broken wire or if the contacts points are burnt..
How do you calculate load on die wire drawing?
how to maintain hardness of wire ,before zinc polish or we can maintain after zinc polish.
What is the probability of not getting a 2 or not getting a 5?
The answer depends on what the experiment is: drawing a card, rolling a die, with a spinner, ...The answer depends on what the experiment is: drawing a card, rolling a die, with a spinner, ...The answer depends on what the experiment is: drawing a card, rolling a die, with a spinner, ...The answer depends on what the experiment is: drawing a card, rolling a die, with a spinner, ...
Can you die from drawing with pen on your hand?
no.
How do you die from a jellyfish?
if you get stung by load at once
When did Lester Wire die?
Lester Wire died on 1958-04-14.
What color wire do you connect to the dimmer wire from radio?
Don't connect the red wire or you will die.
Why the bird cant die if there stand on 1000 volts wire?
It is only standing on one wire thus the circuit is not closed so electricity cannot flow.however,when it is standing on two wire,it will die. I guess so...
When did mirette gateau die?
Mirette on the high wire!
Why wont birds die on a wire?
Mainly because wires are insulated. In the case of being on an uninsulated wire the bird isn't grounded since both feet are on the wire.
What are the release dates for Wire Service - 1956 Until I Die 1-9?
Wire Service - 1956 Until I Die 1-9 was released on: USA: 29 November 1956
What if you die in Majora's Mask boss fight?
If you die during a boss fight, you'll need to load from the latest save.
List the Various types of dies?
First : For Shearing Operation 1- Progressive Die 2- Seperated Die 3- Compouned Die Seconed : For Bending or Deep Drawing 1- Combiation Die
