First,remove all current and voltage sources ie replace voltage source with a short and keep current source open.Now draw the equivalent resistance-only circuit and find the equivalent resistance as viewed from the terminals of the circuit.
for calculating the voltage drop in ckt first of all you have to calculate the total resistance of the ckt as well as total current also then applying ohm's law v=IR u can calculate the voltage drop across a ckt While the answer is correct you might investigate thevenin theory.
its total resistance in ckt
u can't avoid resisters in ur ckt because even the components using in ur ckt hav its own resistance........ if u r not using a resistance in ur ckt u cannot vary the parameters like power voltage current etc.. such ckt is a vaste
What is the torque converter ckt performance?
as we know that sequential ckt = combinational ckt + feedback So if we clear the hazards of combinational ckt then also some type of disturbance left in the ckt .That disturbance is known as ESSENTIAL HAZARDS.
In a non-reactive ckt, a simple measurement with an AC voltmeter is all that is needed. In a reactive ckt, you must first address power factor, which can be metered also, and combined with the apparent voltage as above to calculate true rms.
inductor is used in ckt because it will work as controling current device
To calculate the resistance for a slip ring motor, there is an equation that must be solved. This is Torque = S/R. S is the slip of the motor and R is the resistance of the motor.
Resistance is resistance , no matter if it is contact resistance or any other resistance. And formula is R = V / I.
CKT is electrician short hand for circuit. A circuit is everything powerd by on circuit breaker
as while designing alternator we have to consider two ckt. i.e. electrical ckt.& magnetic ckt. and electrical ckt.is designing by considering current & magnetic by volt.thats why rating is in kva.
In parallel ckt voltage in all branches will be same, its different in series ckt