Install the calibration slug on the lip of the backing plate
Press the F key
Press the 1 key
lower wheel guard
pres spin key
display reads CAL SLU
should spin for about 30 seconds
display reads CAL 0
Remove calibration slug
lower guard and spin
Display should read CAL GOOD
when i calibrate my FMC wheel balancer i only get cal o not cal good at the end
You can get your FMC/John Bean 2500/4100 or 5800 repaired @ ADER inc.
http://www.agequipment.co.uk/fmccal.html
Is made by snap on and is usually a john bean balancer with FMC name on it
there, thanks for answering. Can you get me a copy of the user manual please? Gretings Ad LBS
Operators Manual: http://www.snaponequipment.com/common/op-manuals/jb/past-products/4100_om.pdf
http://www.snaponequipment.com/common/op-manuals/jb/past-products/4100_om.pdf
http://www.agequipment.co.uk/fmccal.html
Mine is doing the same thing playa did you figure out a fix?
Directly, it means one of the force sensors is reading low. I think the left one. But, on my 4100 balancer, i had an issue with the angular position sensor (the encoder wheel) which for some reason gave me the same error.
As of July 2014, the market cap for FMC Corporation (FMC) is $9,118,969,438.08.
The symbol for FMC Corporation in the NYSE is: FMC.