Start by disconnecting the negative battery cable at the battery.
Remove the radiator.
Remove the drive belts and crankshaft pulley.
Remove the Vibration Damper (Harmonic Balancer) bolt. Use a puller and remove the Vibration Damper.
Reverse these instructions to reassemble. (Tighten the Vibration Damper bolt to the correct torque)
They are on the harmonic balancer but are they on the drivers side or on the passenger side?
The flywheel has to be held in place by a holding tool, Remove the mounting bolt, then use a balancer remover to pull the harmonic balancer.
With a harmonic balancer puller.
do the harmonic balancer have a seal for anti-freezer
Harmonic balancer replace
The harmonic balancer is located on the front of the crankshaft
A bad harmonic balancer can cause a knocking noise. The harmonic balancer doesn't actually produce the noise, but it can cause the noise in the engine.
The harmonic balancer tool is made especially to remove the balancer. Some stores will loan you the tool with a deposit.
take the serpentine belt off and then take the crank pulley off the balancer and then you will need a puller to get the balancer off the crank.
how to replace harmonic balancer on a 2000 infiniti i30
hay i am jitendra haldar can you Harmonic progression explane with examples
The harmonic balancer must be removed to change the sensor because the crank position triggering rings on the back of the balancer are entwined with the pick-up, Sorry