0
This may sound bad but it really is this easy.
Find O2 sensor (there are two or three and some have four) that you need to change
Unplug from wiring
Remove using wrench or special socket if you have the special socket
Screw in new gently!
Plug in.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Which o2 sensor do you change with a PO138 code in a Jeep Liberty?
under the driver side and after the pre catalytic converter ( the second sensor). regards.
Oxygen sensor location for a 2005 jeep liberty?
The O2 sensors are on either side of the catalytic convert in the exhaust system.
Where is the bank 1 O2 sensor on a 2003 Jeep Liberty 3.7 engine?
Bank one is the driver side on a 3.7L. There will be an upstream ( sensor 1 ) and a downstream ( sensor 2 ).
O2 sensor relay location on 1996 Jeep Cherokee 4.0?
location of relay for heated o2 sensor 1999 jeep Cherokee sport
Where is the o2 sensor on a Jeep Grand?
In the exhaust pipe.
What might cause the engine light to come on in a 2004 Jeep Liberty?
Quick answer: Gas cap or 02 sensor Or, it could be anything. When mine came on (04 Liberty Sport) I bought a scan tool at Sears. Turns out it was an O2 sensor.
How to change an o2 censor?
To change an O2 sensor you need to disconnect the wiring harness from the sensor. Use an O2 sensor socket and ratchet set to remove the old sensor and replace with the new one.
How do you change the oxygen sensors in a 2001 Chevy Metro?
to change o2 sensor ,you need to buy a o2 sensor socket from a parts store then disconnect neg terminal on battery ,after that disconnect wire connecter on o2 sensor and remome o2 sensor
How do you bypass an o2 sensor in Jeep Patriot 2008 bank 1 sensor 1?
You do not, you repair the problem.
What is diagnostic code 21 for a Jeep Cherokee 1993?
O2 sensor or wiring
02 jeep liberty O2 sensor circuit slow respones bank 2 sensor 1 check light?
Its located in the right exhaust downpipe just before the mini catalytic converter. It referered to as 2/1. John
Where is the O2 sensor on a 2000 jeep wrangler?
It's in the exhaust. It screws into the catalytic converter.
