* Remove rear wheel * Remove brake drum
* Pry off grease cap * Remove cotter pin, adjusting nut & flat washer * Wiggle the hub to push the outer bearing out * Lift the hub off * pry off the oil seal to remove the backside bearings Re-installing note: Tighten the nut to 18-23 ft. lbs. while rotating the hub to set the end-play. Back off the nut and retighten it to 18 inch lbs
See "Related Questions" below for more about removing the drum when it doesn't want to come off.
change the blower motor the bearings have gone bad in it
No 2011 Mercury Sable model , but there is a 2011 Ford Taurus
99% sure the Taurus radiator will be a perfect match to the Sable's.
No, a Generation 2 (1992-1995) Taurus/Sable Windshield will NOT fit a Generation 3 (1996-1999) Ford Taurus/Sable.
No they do not
mercury sable
The Mercury Sable and the Ford Taurus will have DOC in printed on the engine if they are dual overhead cam engines. The symbol should be on the top of the engine.
Yes, it is identical.
Yes.
Yes, it does.
Just one handles the job. See "Related Questions" below for more about Taurus/Sable fuel pumps
Yes, they will fit.