It is attached with two or three Phillips head screws. Unscrew, remove old lens, put in new lense, replace and tighten screws. Very easy to do.
Remove the dome light lens, pull the old bulb out, and replace with new bulb; replace the lens.
Very easy, open the bonnet. On the indicator you will see a tab. Simply gentle lift the tab and slide the whole indicator forward. The lamp holder will come out with a twist.
Increased water pressure can change the shape of your eye. If this happens, it is always an indicator to get your eyes checked professionally.
Under the housing of the front indicator you will find a single screw, loosen this several turns until the mirror can be fairly easily withdrawn from the housing, you can now access the indicator, the rear one is a simple matter of removing the cover from the rear of the lens.
Take the whole lens out
Go into your local car shop an ask for a orange bulb for your car,that is if you have white lens cover,if you lens cover is orange just a standard bulb.
Found it behind the right headlight. Remove indicator lens, front grill then head light which gives access to the horn.
Front or rear? Just change the bulb or change the lens housing?
How do you use the "AV" indicator in the contact lens.
If its like a 99, you have to remove the entire front bumper. That's what I had to do on mine. It was a total pain! Good luck!
On top of the license plate is a clear plastic lens with 2 screws in it. Take it off. Then a bulb slides into the holder, then replace the lens. There are 2 bulbs. One on each side.
four steps remove front grille plastic rivets push in remove indicator lens it slids unbolt headlight unit bolts again slids out just tip up as its almost out remove metal clips round lens little screw driver will do then reverse directions