I am not familiar with this car in particular but ball joints are either pressed in, bolted, or riveted into the control arms. On top of the ball joint is the steering knuckle, usually the ball joint is held into the steering knuckle with a pinch bolt. Which is easily removed. After the pinch bolt is removed you must force the control arm away from the steering knuckle which sometimes requires the use of an air hammer. Depending on what type of fit the control arm has with the ball joint, you will either need a special tool to press out the old ball joint and press in the new one, if the ball join is a press fit. Or if it is riveted you will have to carefully drill out the rivets and replace the new one with bolts. If it is bolted in you simply loosen the bolts and knock out the old ball joint. Installation is reverse.
how to change an alternator Mitsubishi shogun 3000 v6
Refer to your service and user manual on how to change an alternator ground wire on a 1994 Mitsubishi 3000 GT.
http://www.3sx.com/faq/manuals/
Overheating?Low oil Level?Worn out?
Bad struts can cause vibrations while coasting in first gear on a 1993 Mitsubishi 3000 GT VR4. A bad tire can also cause this.
3000gt is a Mitsubishi car.
in the trunk
six
1999
This is not an easy job. You have to remove the trim pad first. TAke it to the auto trim shop.
it is located behind the radio
boo