there are two or three nuts under the steering colum pretty hard to get to disconnect the brake lines from under the colum and it should come right out replace and it should be all good i did it had know idea what i was doing but it went pretty easy
you say alot of prayers!
The power brake booster on a 95 Chevy Blazer is replaced by draining and removing the master cylinder, unbolting the booster, and removing it from the vehicle. A new cylinder is then put in its place and bolted on.
Bad brake booster.
Sounds to me like your Vacum booster behind the master cylinder is weak or bad!
you most likely need to change them
The relay is on the left side of the power brake booster/.
Look in the area of the left rear of the valve cover or chase the brake booster line.
how do you remove thekeeper that holds booster rod on brake pedal
first off the brake booster is the round bell lookin thing on the outside of the firewall engine side first u are gonna take off the master brake cylinder which is the thing with the resovoir for the brake fluid there should be two bolts dont take off the lines just loosen the bolts and pull the brake cylinder off the booster now on the booster itself there are 4 or 6 bolts loosen them and under the steering wheel u will see the rod that goes to the brake booster take out the cotter pin on that rod and the brake booster will come right out once out take off the rod on the back side of the booster screw it in the new booster and put back on do all ur bolts and u are good to go
need to find out how to replace a power brake booster in a 2002 Chevy silverado 2500 HD
Purchase a repair manual for that vehicle from your local auto parts store if you are not familiar with brake repair.
Master cylinder, is the brake fluid reservoir. It is mounted on the brake booster, on the firewall, driver's side.Master cylinder, is the brake fluid reservoir. It is mounted on the brake booster, on the firewall, driver's side.