Most cam sensors are attached with a single bolt.
just a matter of locating the sensor, removing the wire to it then unbolting it.
Refitting is the reverse of the above.
The sensor on the CAM SHAFT!
The cam sensor is in the distributor.
CMP= Cam Shaft Position Sensor.
The cam sensor is inside the distributor.
no
Both the CAM and Crank sensor are on the front of engine. The cam semsor is to the right and held in with two smaller screws. It is actually a sealed Hall Sensor device but pretty easy to change.
The cam sensor is inside the distributor.
P0340 is a failure in the cam shaft sensor circuit. That can prevent the engine from running.P0340 is a failure in the cam shaft sensor circuit. That can prevent the engine from running.
were is the cam shaft sensor
I would like to know where the cam sensor is on a 1999 pathfinder and is there one or they calling it a crank shaft sensor The cam shaft position sensor is located in the distributor.
no there is not
The cam sensor is inside the distributor.