Look behind the alternator. It is held only by one 10mm bolt. Disconnect the cam sensor, then remove the 10mm bolt and pull up on the sensor. It should come right out. Take a rag and clean out the are where the sensor goes in. A quick wipe should do. Push in the new sensor and tighten the 10mm back in place. Connect the harness back, male sure the connector it plug all the way in. Connect the negative cable back to your battery and your done. Took me less than 5 minutes.
The camshaft position sensor on a 95 Dodge 2500 3.9 is located inside the distributor, under the rotor.
The camshaft position sensor on a Dodge Ram 2500 5.7 engine is located at the rear of the camshaft near the top of the motor. It monitors the motion of the camshaft and constantly updates the vehicle's computer.
Yes it can
Camshaft position sensor circuit malfunction.
Yes, the cam sensor is inside the distributor.
The camshaft position sensor, which is located inside the distributor, is a pretty easy component to test on the 1992-1995 5.2L/5.9L Dodge Ram 1500/2500 pickup.
Below the injection pump, on the back of the timing cover.
under the rotor in the distributor unplug the wires take off the rotor and pull it out
the cam sensor is under the distributor cap.this engine uses the distributor pickup as a cam reference since the dstributor is cam driven
blak
It is located in the rear of the timing gear housing under the fuel injection pump.
No.