0
How do you change a drivers side window in a 1993 crown Victoria?
Wiki User
∙ 12y ago
When i replaced the rear windows of my 1992 crown Victoria, i had to drill out the rivets that hold the glass on the regulator, then you have to jimmy the window around and pull it out of the top (or just break it and shop vac the glass but that's time consuming)
next you take the new window and carefully work it down into the door as if you were putting window down normally, it works, i did it, you just have to play around for a bit. to replace the rivets, i used bolts and locknuts with washers (BE CAREFUL when tightening these, don't hulk them because i broke a window tightening them the first time i did this. MOST IMPORTANT, make sure you have the glass in the track inside the window, adjust the height on the regulator by simply toggling the switch and pop in the bolts.
once you take the door off and can see inside, you will understand most of this. windows are cheap at junk yards, i have a harrys u-pull-it by me and i got mine for about 12 dollars a piece. of course youll need a power drill with you to drill out the rivets.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Where is bank 2 on a 2001 Crown Victoria with the 4.6?
Bank 2 is the drivers side of the engine in your Crown Victoria
How do you remove the window from the drivers door on a 92 Ford Crown Victoria. It's an electric window.?
Its not really a tough job. Once you have removed the panel, you will see what you have to do. Just be careful of all the wires.
How do you adjust the automatic window on your ford crown Victoria?
what year?
How do you fix a power window that goes down but not up on 95 Crown Victoria?
there is something wrong with your switch in the door you may have to change it
Where are the banks located on 2000 Crown Victoria?
On a 2000 Ford Crown Victoria : Bank 1 is the passenger side of the engine , Bank 2 is the drivers side
Where is the trunk pop button on the 2003 mercury Crown Victoria?
On a 2003 Ford Crown Victoria : The trunk lid release button is on the drivers door trim panel
How do you change an oxygen sensor on a 1981 ford ltd crown Victoria?
The 1981 Ford Crown Victoria does not have an Oxygen sensor.
How do you change the starter from a 1998 crown Victoria lx?
How do you change the starter from a 1998 crown Victoria lx? Click on the link in the "Related links" section of this webpage.
How do you install a Ford Crown Victoria window?
If it is a older Crown Victoria,( had to replace a window in 89 grand marq.) you have to take off the door panel to get to the window motor and i believe also there are some springs too, and put it on track. Isn't much of a answer you was looking for but it's a start...
Picture instructions on replacing window regulator in 1998 crown Victoria XL?
need instructions on replacing window regulator
How do you change a fuel filter in a 2001 ford crown Victoria?
If it is the same as all the other years, it is under the car, around the drivers side rear wheel. Once you look at it, it is easy to change.
How do you replace the electric window switch mechanism located in the drivers door on a 1996 Ford Crown Victoria?
See the link here to learn how to remove the window switch assembly (steps 1-3)... http://www.autoclinix.com/Mercury/Front%20Speakers2.htm
