answersLogoWhite

0


Best Answer

take off your grille hood and wheel you'll see all the bolts there's two in the door and one at the bottom om of the fender on the door side i think that's it hope it helps i know its sucks

User Avatar

Wiki User

โˆ™ 2009-09-08 03:19:28
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: How do you change a front fender on 99 s10 extreme?
Write your answer...
Submit
Related questions

How do you change the front shocks on 2000 Chevy S10 pickup?

how to change front shocks in 01 Chevy s10


Where is starter motor relay located on 94 s10 jimmy?

left front fender well


Is the fender for a 1995 s10 compatible with a 1999 s10?

Yes.


1988 Chevy S10 blazer fuel pump relay location?

Located at front driverside fender inside the engine bay


Where is the vacuum reservoir tank in a 1999 S10?

Inside the driver side front fender, it should be located near the brake system.


Will a fender from a 98 S10 fit on a 95 S10?

Yes, same part # for 98 and 95.


How do you remove the piece the filter screws into from the fender of a 93 s10 Blazer Removed all bolts Need to remove fender Can't do it with piece attached Is it welded to fender?

I looked at my remote filter on my 93 S10 Blazer and it is bolted to the inner fender which shouldn't need to be removed to remove the fender.


How do you replace front fenders on 1993 S10 blazer?

To replace the front fenders on a 1993 S10 Blazer, unscrew the bolts holding the old fenders in place. There are also rivets that have to be removed around the wheel well on both sides. The bolts are located inside the hood area on top of the fender.


Where is the PCM located on 2000 S10 pu?

its on the passanger side fender


Will Chevy s10 4wd wheels fit on 2wd s10 with rubbung tha inside fender?

no and it would look goofy because of the offset


How do you change a heater core in a 1996 s10 pick up?

Open both front doors and remove everything from the front seat to the firewall, no kidding.


Were is the oil filter located on 92 Chevy s10 blazer?

I think it is under the hood, drivers side, up front close to the radiator. It is mounted to the drivers side fender behind headlight


How do you change a heater core with air on a 1991 Chevy s10 Tahoe?

Open both front doors and remove everything from the firewall to the front seat. No joke.


What size allen wrench is required to change front brake pads on 2000 Chevrolet s10 truck?

3/8"


How to change spark plugs on 1999 Chevy S10?

The front left can be changed from under the hood. The rest must be changed from under the fender. To change the middle one on the drivers side you must either use a wrench or unbold the stearing shaft and move it out of the way. I have changed pluggs on a 1994, 1999, and 2 2000 S-10 trucks and Blazers.


Where is the oil filter located on a 1994 chev s10 blazer v6 vortec?

attached to the engine. it will look like a small coffee can, possible say fram on the side of it. -Richard B ------------------------------- The oil filter on these is located at the front drivers side fender. The easiest way to change the filter is to remove the air filter box...no big job. Then look towards the front of the Drivers side fender behind the headlight and you will see the filter. These are a remote location filter - The reason they put it there is because of the front 4 wheel drive differential. The front diff makes the remote location a necessity.


How do you change the oil pump in a S10 pickup 1991?

how do you change the oil pump on a 1991 s10 pickup


Does a s10 pickup have a solid front axle?

No, it has independent suspension in front.


Will a front differential from a 2000 s10 fit a 1996 s10?

No it will not, It is all different. Actually yes it will i have to correct you om that i have a 96 blazer same front diff as an s10 and 96 to 03 are the same i just put a 2000 front diff in mine


How much lower is the front coil springs on a Chevy extreme compared to a stock s10?

the spring height is 1.25 in. shorter but the spring rate is different and the leaf springs are also different.


Chevy s10 4x4 what year parts will fit on the front end?

1995 chevy s10 what years are the front end body parts interchanable


How do you change front wheel stud on Chevy 1992 s10 blazer?

The front wheel stud on a 1992 Chevy Blazer S10 can be changed by jacking the vehicle up, removing the wheel, and unbolting the caliper. The rotor assembly can then be removed, and the wheel stud pressed or hammered out of its seat.


How do you change Front Shocks on a 2001 Chevy S10 pickup?

Lift the front of the vehicle up and support it with jack stands under the lower a-frames. Remove front wheels. Unbolt front shocks and remove them. Reverse order to install.


Where is the ecm located in a 1996 Chevy s10 pickup?

Under the hood, on top of the passenger side inner fender.


Where is the oil filter on a 1993 Chevy S10 Blazer?

It on the driver side right behing the headlight in the fender wall