Take the Cav to the dealership. Its worth the money to get them changed there.
or you can jsut go to an auto parts store and buy them yourself. They roughly are $40-$50 per injector. If its a 2.2L you just unscrew the screws holding it down and remove the bar that holds them down. Then you can simply pull them out. Careful not to let it spray ya, cause there will be some fuel in there. You should also see 2 orings per injector. If you only see one, just stick the injector back in the hole, the other one should come out with it when you pull it out again. Hope this helps and it will save ya some $$$
To relieve the fuel pressure: remove the fuel pump relay and fuse (under the hood, left side of engine compartment), start the car and let it run until it dies, turn the engine over a couple of times to remove as much fuel from the lines and fuel rail as possible. This will reduce the amount of pressurized fuel and reduce the mess of removing the fuel pressure regulator and the injectors.
Instructions on how to change the rear hub wheel bearings on a 1996 Chevy cavalier
Take it to a repair shop.
Yes
NO.
what are the signs for replacing the oil gasket in a 1996 Chevy cavalier
where is 1996 cavalier convenience center
new injector
do you mean cavalier hand brake?
Check the fuse!
2.7
check this site out
Providing your cavalier has a 2.2l, this is what your looking at.