When it gives you trouble otherwise, leave it alone.
When it starts leaking are making noise.
if it is a vortec, there is a fuel line under the upper intake that goes from the manifold to the injector. check it for cracks and leaking or the injector itself. EGR Valve
You'll need to replace the stuck injector.
remove two torx screws that hold down the bracket which hold down the injectors. then you can pry out the injector whit an screwdriver but becareful not to damage the injector or o-rings
No there is not, Probley need to replace ingnition module in the distributor if the injectors are not working.
if it is not making any noise,or leaking from bottom of pump. Releif hole is on bottom of pump,if leaking replace pump.
Oil pump driveshaft (also referred to as distributor) o-ring is bad. Replace, and oil will stop leaking there.
how to remove fuel injector plug in on a 2007 chevy suburban 5.3
It is inside the upper intake manifold. It is attached to the fuel injector poppets with a bracket. To inspect/replace you must remove the upper intake manifold.
If you have spark on #4 it is probably a faulty fuel injector.
to reset an injector , is a specialist job if injector is faulty, it needs replacing
where is it leaking from?
replace or repair. It will only get worse.
can i pull a chevy caviler motor 1998 2.2 4cylinder from the top or do i have to drop it from below
Evidently pretty hard. My mechanic took 4 hours but he is the slowest most depressing man to watch work....
If you are sure that it did not freeze and crack the block, Then the intake manifold gasket is leaking. That is a common problem with the vortec Chevy engines. You need to replace the gasket with a factory Chevy gasket from the dealer.
The cost to replace a leaking brake line on a 1996 Chevy 1500 truck can vary. For example if you can purchase the part used the cost can be as low as $100. However, the cost to have the service work completed on the part can also increase the price depending on the mechanic prices.
what type of Chevy 5.7?
idle control valve (delphi)
06.0 on a 4cylinder 2wd s10
Injector is not fully shutting off and is leaking down and loosing fuel pressure. This will cause fuel to accumulate in the oil pan, and mix with the oil. This is a bad thing, and will cause engine damage. Replace the faulty injector, and change the oil/filter.
your heater core is leaking
If coolant is leaking inside your cabin, you have a leak in the heater core. The only repair is to replace the heater core. Most auto parts stores sell them.