Remove the access panel in the rear of the trunk. Take off the power conector. Take off the hoses. In my case no fuel came out. Mark the inside one so you don't mix it up. Loosen the bracket around pump with a socket wrench. Pop .. out comes the pump. Do the reverse to install. Not all pumps have the same power connector. You may need to splice some wires. My used replacement pump came with a different connector but wires were the same color coding. It's not a hard job providing you have access in the trunk. Otherwise you need to lower the tank and that must be a pain to do your self.
Dodge Intrepid was created in 1993.
where is the crankshaft sensor located on a 1993 dodge intrepid
O,YEA AND I FORGOT TO MENTION IT IS A 1993 DODGE INTREPID...
in the trans
About 18 gallons
Dodge does not use inertia/reset switches.
The 1993 Dodge Intrepid had two OEM tire sizes. The factory fitments for this vehicle were the P205/70/15 and P225/60/16 sizes.
The curb weight of the Dodge Intrepid in 3,318 pounds of 1,505 kilograms. It was produced for model years 1993 until 1997.
check your alternator it might be bad.
NoNo
When changing out the spark plugs of a car, maintaining the gap is important to help the car run correctly. For a 1993 Dodge Intrepid the spark plug gap is 0.04 millimeters.
Change at 105,000 miles. Warning: (Interference engine, if the belt breaks serious engine damage will occur)