loosen the timing belt.
take out all the bolts holding the cams in starting from the ends and working your way in towards the middle EVENLY!
remove the cams.
the bolts for the head are now visible
remove them the same way as the cam bolts.
use new valves, springs and retainers unless the new head has them already.
use your torque wrench to tighten to factory spec. following specified order in reverse...
on a acura integra type r if you brake the head bolts what do you do on a acura integra type r if you brake the head bolts what do you do
no the 1993 acura integra headlights will not fit the 1995 integra, 90-93 acura integra are more of a rectangle shape as to where in the 1994-2001 integras except the type r, have round head lights
Replacing a 1992 Acura Integra head gasket will cost approximately $500. The exact cost to replace the head gasket is dependent upon several different factors.
The intake manifold on a 1990 Acura Integra connects to the head of the engine. Loosen all of the nuts from the manifold to the head, disconnect the throttle body, vacuum lines, fuel injectors and coolant lines then pull the manifold from the head.
The torque specs for a 1995 Acura Integra GS-R cylinder head and cam gears is 128 lb. ft at 6,200 rpm. It also has 170 hp at 7,600 rpm.
how to change head gasket on 1997 acura
a vtec head, and a vtec enabled computer
Replace the head gasket. Major repair that should only be done by a professional with the proper tools and skill.
I believe the crx si came with a d series engine, unless it was a jdm crx. basically if your crx has a single over head cam motor ( SOHC ) then it is D series which means no your crx tranny can not bolt up to an integra. Since integras are all B series engines or Dual over head cam ( DOHC ) usuall the b18a1 or b1 unless gsr .
On the passenger side of the center console behind the head unit for the stereo.
check your thermostat and if its opening up then you have a blown head gasket
see it doe snot matter what it is but u should know what you are saying ok.!!