The intake manifold on a 1990 Acura Integra connects to the head of the engine. Loosen all of the nuts from the manifold to the head, disconnect the throttle body, vacuum lines, fuel injectors and coolant lines then pull the manifold from the head.
The IAT is located on the intake manifold right behind the Fuel Rail
left rear top of the engine on the intake manifold mounted and held in by screws
The sensor is located on the intake manifold or air plenum. It is removed and installed in straightforward fashion; disconnect the wiring connector and remove the mounting screws. Remove the sensor.
Driver side if intake manifold last cyl. up on top
You can remove the governor on an acura integra by having the ecu chipped.
on the intake manifold you should see a vacuum line coming from it connecting to youe throttle body
air filter might be clog/needs to be replace or if u have a aftermarket intake the whining noise is nuttin. its just sucking up air int other intake manifold
22
You need to replace your IAC Valve (Idle Air Control Valve) It's located in the back of Your Intake Manifold.
Your IAT is located on the right side of the intake manifold on a factory models and on a customize engine or Turbo charge engines should b along the intake pipes.
Yes
a hammer