Acura Integra

How do you remove the governor on a Acura Integra?

363738

Top Answer
User Avatar
Wiki User
2006-03-13 21:32:09
2006-03-13 21:32:09

You can remove the governor on an acura integra by having the ecu chipped.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Remove the bolts that hold the distributor cap onto the distributor. Once this is off the rotor can be reached and replaced on a 1994 Acura Integra.

User Avatar

91 acura integra has a b18 91 acura integra has a b18

User Avatar

See http://www.ehow.com/how_4506404_replace-rotor-acura-integra.html

User Avatar

The front bumper on a 1991 Acura Integra is held on by several mounting screws. Remove all the screws and gently pull the bumper off the remaining mounting clips.

User Avatar

How to install a boost gauge in a acura integra?"

User Avatar

The factory tape deck on a 1996 Acura Integra can be taken off by removing the center console. Once the console is off remove the remaining mounting screws on the radio and pull it out.

User Avatar

The brake lights are located in the trunk of a 1997 Acura Integra. To replace them open the trunk and find the plastic housing. Remove and replace the bulbs.

User Avatar

To change a starter from a 1993 Acura Integra remove the mounting bolts that connect it to the transmission. Then unplug the solenoid from the wire harness. Install the new unit.

User Avatar

When looking to buy parts for an Acura Integra then this may be possible by visiting the Acura Parts Online website that sells official parts for the Acura Integra.

User Avatar

how to install a altinator on a 1991 acura integra

User Avatar

Internal diagram for a acura integra manual transmission

User Avatar

where is locate the main relay on 1996 acura integra

User Avatar

1999 fan sencer for acura integra

User Avatar

The radiator support on a 1991 Acura Integra is held on with several bolts. Use the appropriate sized socket and loosen all the bolts. Pull off the support.

User Avatar

wiper intermittent relay 1990 acura integra

User Avatar

Acura Integra GS-R was created in 1992.

User Avatar

Bearings require a mechanical press to be properly changed in an Acura Integra. Remove the hub from the vehicle and take it to a press. The machine will properly install a new bearing and ensure a safe install.

User Avatar

The headlight assembly on a 1998 Acura Integra is held on by brackets. To remove them loosen the bolts on the brackets. Pull the housings off. Install the new housings by placing them on the brackets.

User Avatar

A 1998 Acura Integra fuel pump is located under the car. If you jack up the vehicle and get under it and remove the fuel tank the pump will be located inside the fuel tank.

User Avatar

From the Haynes Acura Integra Repair Manual, 156 in-lbs.

User Avatar

where is the flasher relay located 94 acura integra


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.