Heater Cores and Blower Fans

How do you change a heater core on a 1983 Chevy pickup?

707172

Top Answer
User Avatar
Wiki User
2015-07-15 21:12:39
2015-07-15 21:12:39

On 83 heater core 4 or 6 nuts on fire wall under hood remove hoses go into pass side and remove glovebox if needed and disconnet cables and pull heatererore box out change heat core

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

i have a 1983 Chevy k10. it uses GM corporate 10 bolt axles with 2.73 gears

User Avatar

Are you asking about the heater blower motor or the engine cooling blower motor?

User Avatar

Drain the water from your 1983 Chevy Caprice Classic cooling system. Remove the heater core water supply hoses. Remove the heater core retaining bolts. Reverse the process to install the new heater core.

User Avatar

yes 1973 to 1983 will work because this is before 1984 when wipers moved to the column in the full size trucks. it will bolt right in directly. good luck

User Avatar

This is not easy. Get a manual on your car from DISCOUNTAUTOREPAIRMANUALS.COM

User Avatar

can some one tell me if you can change the gasket on the back of the injection pump on 1983 mazda diesel pickup with out any problems

User Avatar

for 24.99 auto zone has a repair manual,chilton or haynes.

User Avatar

They generally bolt the ground cable directly to the engine block.

User Avatar

You can change your 1983 Chevy single headlight set up to a dual?รฆheadlight set up. You will need to make several modifications to the front grill.

User Avatar

There is NO adjustment. It is adjusted automatically through the hydraulic slave cylinder. Probley time for a NEW clutch kit.

User Avatar

Take to a shop, there is about 25 or 30 blots to take out and not easy to get out

User Avatar

i would like to know the same thing we have an 1983 k10 stepside it only has 6 boards and i cant find any demensions for this truck

User Avatar

How much is a 1983 chevy truck worth?

User Avatar

There is no choke light in a 1983 chevy, no matter what model you have.

User Avatar

Not sure what you are asking there is a white wire on the door switch for the interior lighting.

User Avatar

Yes but you will have to change the Trans and also add Chevy motort mount brackest to the cross member.

User Avatar

Where is the control module located on the 1983 Chevy blazer

User Avatar

The part number for the TYC parking light for a 1993 Chevy S10 pickup is 12-1247-01. The list price is $30.35, but they can be found online for $21 to $25.

User Avatar

If equipped w/carb. check front lower end of engine follow the fuel line If fuel injected in the fuel tank

User Avatar

1983 Chevy 305 diagram, waterneck, thermostat housing and fittings

User Avatar

Drain the cooling system.Remove the heater hoses from the core tubes at the firewall.Remove the heater duct and heater case side cover from under the instrument panel.Remove the core retaining clamps. Remove the inlet and outlet tube support clamps.Remove the core.

User Avatar

go to autozone.com and enter your 1983 info and look up water pump,then on right side of screen,click on repair guide and it will tell your how to remove and install new one.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.